Causes and Solutions of Un neat Peeling of Rotary Cutting Machine

The rotary cutting machine is a common mechanical equipment for sheet metal production now, and it is inevitable that there may be a problem of uneven peeling when it is often used. Today, the technicians of Feixian Jinlun Machinery Factory will show you the reasons and solutions for uneven peeling.

1. The uneven peeling of the rotary cutting machine may be caused by the uneven location of the machine. The rotary cutting machine should be placed on a flat cement floor or floor to effectively avoid this problem.

2. The NC box will affect the peeling flatness of the rotary cutting machine. If the NC box is not well adjusted, there are quality problems, and the machine has been used for a long time, the peeling may not be neat. The CNC box shall be repaired or replaced according to the specific conditions.

3. It is a single roll problem. The single roll will also affect the finishing of the peeled veneer of the rotary cutting machine. If the single roll is not straight, the veneer will be irregular.

In addition, new users should be reminded that if they are unfamiliar with the use of the machine or have no relevant experience in operating the machine for a long time, they must find professional maintenance technicians to repair the machine after it breaks down.

In fact, if the peeling of the rotary cutting machine is not neat, it is easy to find the problem by carefully observing the operation of the machine, and then solve it specifically. In addition, if you want to efficiently produce the rotary cutting machine, you should do a good job of regular maintenance, and regularly check the wear of accessories after each use.