Some common problems of veneer quality of non card rotary cutting machine

Card free rotary cutting machine is our manufacturing industry can be used, but in the use of the process found that the product will have a failure, today for you to introduce a few common veneer problems, now let's take a closer look at it?

We found that the veneer will roll up during the manufacturing process, which is caused by the narrow knife door or too high tool holder. At this time, we need to solve this problem. We can loosen the ram screws and adjusting screws on both sides of the machine, relax the knife door, lower the height of the cutter, and then tighten the screws. In this way, the problem of wood veneer rolling can be solved. Secondly, the thickness of the veneer is uneven, which results in the damage of the encoder or electronic ruler. To solve this problem, it is necessary to adjust the frequency to 2Hz, observe whether the diameter change of log is continuous, and replace it if there is a pause.

Finally, because the veneer made by the card free rotary cutting machine will be wavy. Check whether the output current of the frequency converter is greater than 5 a when idling. If the current exceeds that, adjust the machine to check whether the resistance caused by poor lubrication is too large.