mobile menu show

How to deal with common faults of rotary cutting machine

16 Jul,2020

Rotary cutting machine manufacturer products can play a greater role in life, but after using for a period of time, we found that it will have some problems, now we will have a careful understanding.

How to deal with common faults of rotary cutting machine

The peels from the rotary cutter always roll up. In this case, we can loosen the ram and the adjusting screw at both ends of the machine respectively, relax the cutter door by more than ten markets, lower the knife to two millimeters, and then tighten the screws on both sides. In addition, if the wood is too dry, spray more water on the wood, and the wood skin will roll better next time it is used.

The peeled skin is obviously wavy. If the feed resistance of the rotary cutter is too large, it is necessary to adjust the current of the frequency converter below 5a, or add some lubricating oil; the motor parameter input is not correct. Learn and operate according to the specified parameters in the manual.

China Plywood Machinery Manufacturer
Call
WhatsApp