How to adjust the parameters of card free rotary cutting machine

In order to ensure the smooth operation of the card free rotary cutting machine, it is necessary to accurately adjust its parameters, mainly including which aspects we need to understand next.

First of all, how to adjust the axis of the non card rotary cutting machine? Generally, the processing shaft of a rotary cutting machine will use a thimble to support the processing, and the thimble can meet the coaxiality requirement of 0.01. Therefore, if there is a problem with the axis, you can start to observe from the thimble. If there is a problem with the thimble, the thimble can be replaced. Then, for the pressure of the rotary cutting machine, the triangular ruler can be used to lean against the upper and inner sides of the double flower roller of the rotary cutting machine, and the straight edge should be used to support the top of the single flower roller, and the value at the junction of the lower edge of the triangular ruler and the straight edge can be observed. If the pressure of the rotary cutting machine is to be increased, the gaskets should be added respectively between the single box on both sides and the shoulder of the cutter head; when the pressure is reduced, the gasket must be reduced.

The other is to adjust the cutter height of the card free rotary lathe. When adjusting, the loosening bolts on both sides should be loosened first, then the screws at both ends should be adjusted to make the gap between the knives meet the required height.